Brookes School        British Lyceum in Moscow
Page 4 of 4 FirstFirst 1234
Results 46 to 46 of 46

Thread: Changed Router to МГТС from AKADO, and now can't print

  1. #46
    Join Date
    Apr 2018
    Location
    TX
    Posts
    1
    Thanked: 1
    Hi Belinda,
    We also have a ZTE F670 in Moscow on MGTS and found that after install, any device that was on wifi was able to connect to the internet but was not able to connect to another device on the network, like our printer..... We were able to confirm that the ZTE F670 is the problem as "wireless isolation" seems to be activated regardless of the setting being enabled or disabled. I donít have a solution yet as the issue is the software in the router itself. The issue has been known by ZTE for over 6 months and this has been reported to Ministry of Communications. The plan is to correct this issue with a firmware update that MGTS will have to send to the router once its completed. See attached, you may have to wait till after June.
    12741774.jpg
    Last edited by mrjware; 29-04-2018 at 08:39.

  2. The Following User Says Thank You to mrjware For This Useful Post:

    Hans.KK (29-04-2018)

Page 4 of 4 FirstFirst 1234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •